Skip to content

How to mount BMX pegs

With pegs you can do grinds and stalls. Before you buy, check what axle your bike has.

What you need

  • BMX pegs for your axle size
  • Hub guards to protect hub and driver
  • The right wrench for your axle nuts or bolts

Step by step

  1. Check your axle. Most BMX rear axles are 14mm, many front axles and kids bikes use 3/8 inch. Many pegs come with an adapter for 3/8 inch.
  2. Female axles use bolts instead of nuts. Check that the bolts are long enough for pegs, or use the bolts made for it.
  3. Remove the axle nut on the side where the peg goes. Keep the other side tight so the wheel stays in place.
  4. Put on the hub guard on the drive side or the non drive side if you have one, then slide the peg onto the axle.
  5. Tighten the axle nut firmly. The nut must sit fully on the thread.
  6. Check everything again: wheel centered, chain tension right, peg tight.

Tips

  • Many skateparks only allow plastic pegs or plastic sleeves, they also slide better on coping.
  • Most riders start with pegs on one side only.

Parts and tools in our shop

Pegs | Hub guards | Grind wax

Not sure? Ask us in the store in Cologne or send us a message. More guides →

Previous article How to adjust a BMX U-brake
Next article How to change BMX grips
1