How to adjust a BMX U-brake
Most freestyle BMX bikes use a U-brake on the rear wheel. If it squeals, rubs or does not stop well, a few minutes of adjusting usually help.
What you need
- Hex keys
- New brake pads if the old ones are worn
- A new brake cable if the old one is frayed
Step by step
- Check the pads. If the grooves are gone, replace them.
- Align the pads. Loosen the pad bolt, press the pad flat onto the braking surface of the rim, not on the tire, and tighten it again. The front edge may touch slightly earlier than the back edge, that stops squealing.
- Set the cable tension. Turn the barrel adjuster on the lever until the brake bites early but the wheel still turns freely.
- Center the brake. If one pad rubs, turn the small spring tension screws on the brake arms until both pads have the same gap to the rim.
- Test it. Pull the lever hard several times and check that nothing moves and the wheel spins freely.
Tips
- Clean the rim with a little alcohol if the brake is greasy.
- If you are unsure about your brakes, do not ride. Brakes are safety parts.
Parts and tools in our shop
Brakes | Brake levers | Brake cables
Not sure? Ask us in the store in Cologne or send us a message. More guides →